Jump label

Service navigation

Main navigation

You are here:

Main content

M.Sc. Stefan Höving

M.Sc. Stefan Höving Photo of M.Sc. Stefan Höving

Telephone
(+49)231 755-2675

Fax
(+49)231 755-8084

Address

Fakultät Bio- und Chemieingenieurwesen
Arbeitsgruppe ApparateDesign
Geschossbau 3

Room 509a

Information

Curriculum Vitae

Stefan Höving started studying biochemical engineering at the TU Dortmund University in 2013. He completed his bachelor thesis with the topic "Hyphenation of a Microfluidic Free-flow Electrophoresis Device to a Mass Spectrometer by Electrospray Ionization" at the Leibniz-Institut für Analytische Wissenschaften – ISAS – e.V.. After an exchange semester at the Lehigh University in Pennsylvania, US, he graduated with the master thesis "Development of an Automated Droplet-based Screening System for (Bio-)chemical Reactions " at the laboratory of Equipment Design in 2020. Since then he works as a research associate at the laboratory of Equipment Design, participating in the ENPRO2.0 - VOPA project, focusing on continuous and automated crystallization and precipitation.

Research Topics

  • Continuous particle generation
  • Precipitaion
  • Crystallization
  • Lab automation
     

From his former activities the following publications were achieved:

  • P. Novo, M. Dell'Aica, M. Jender, S. Höving, R. Zahedi, D. Janasek, 2017, Integration of polycarbonate membranes in microfluidic free-flow electrophoresis, The Analyst – the Analytical Journal of the Royal Society of Chemistry, accepted
  • S. Höving, D. Janasek, P. Novo, 2018, Flow rate independent gradient generator and application in microfluidic free-flow electrophoresis, Analytica Chimica Acta, Elsevier, accepted
     

Open Theses

Currently there are 2 open experimental Theses avaliable. Contact me for further Information:

Untersuchung zur Mischbarkeit von Suspensionen auf einem neuartigen quasi-kontinuierlichem Filterband-Kristallisator

Charakterisierung eines Moduls zur Kühlungskristallisation auf einem quasi-kontinuierlichen Filterbandkristallisator

Additional Topic in collaboration with M.Sc. Jens Bobers:

Untersuchung der Anwendungsbereiche eines 3D-gedruckten Open Source Photosensors

Publications

Journal Articles

journalJ. Bobers, J, Grühn, S. Höving, T. Pyka, N. Kockmann

Two-phase Flow in Coiled Flow Inverter – Process Development from Batch to Continuous Flow

Org. Prog. R&D, 2020, doi.org/10.1021/acs.oprd.0c00152


Posters

posterS. Höving, B. Oldach, H. Rohde, N. Kockmann

Temperature control for cooling crystallization on a quasi-continuous filter belt crystallizer

Jahrestreffen der ProcessNet-Fachgruppe Kristallisation, 18.-19. March 2021, online, Germany


Show more publications..

Scientific Theses

BachelorHauke Konstantin Rohde (Supervisor: Stefan Höving)

Entwicklung und Regelung eines Temperiermoduls für die kontinuierliche Kristallisation auf einem Filterband-Kristallisator

TU Dortmund, Fakultät BCI, Arbeitsgruppe Apparatedesign, 10.11.2020

MasterBirte Maria Helga Nierhauve (Supervisor: Stefan Höving)

Development and automation of a Cu-/Zn-nitrate precipitation system on a continuous filter belt crystallizer

TU Dortmund, Fakultät BCI, Arbeitsgruppe Apparatedesign, 26.02.2021

MasterKira Insea Tita (Supervisor: Stefan Höving, Lutz Kaiser)

Commissioning of a miniaturized quasi-continuous belt crystallizer for integrated cooling crystallization and filtration – a feasibility study

TU Dortmund, Fakultät BCI, Arbeitsgruppe Apparatedesign, 11.08.2020

MasterStefan Höving (Supervisor: Jens Bobers)

Development of an Automated Droplet-based Screening System for (Bio-)chemical Reactions

TU Dortmund, Fakultät BCI, Arbeitsgruppe Apparatedesign, 10.06.20

Show more scientific theses..